Chery Tiggo 2009 Service Manual page 1178

5.
CHECK LOW SPEED CLUTCH SYSTEM
• Stop vehicle and turn ignition switch off.
• Disassemble and repair F4A4 automatic transaxle assembly (See Automatic Transaxle Removal & Installation in
Section 08 Transaxle & Transfer Case).
• Check low speed clutch system:
− Check low speed clutch plate
− Check low speed clutch disc
− Snap ring
− Clutch reaction disc
− D-Ring
− Spring retainer
− Low speed clutch drum
− Low speed clutch piston
Is the check result normal?
Yes >>
Go to the next step.
No >>
Replace the damaged components.
6.
CHECK REVERSE GEAR CLUTCH SYSTEM
• Check reverse gear clutch system:
− Reverse gear clutch plate
− Reverse gear clutch disc
− Central support
− Snap ring
− Clutch reaction disc
− Spring retainer
− Reverse gear clutch piston
Is the check result normal?
Yes >>
Go to the next step.
No >>
Replace the damaged components.
7.
CHECK DTC
• Assemble all disassembled components.
• Install the transaxle assembly (See Automatic Transaxle Removal & Installation in Section 08 Transaxle &
Transfer Case).
• Fill the transaxle with new ATF:
− Fill the ATF from the fill tube.
− Reinstall the hose connector disassembled in step 1 and reinstall the dipstick (clean the dipstick before
installing).
− Shift the gear selector lever to each gear position and then shift to gear "N".
− Drive the vehicle until the ATF reaches operating temperature (70° - 80°C) and re-check the fluid level. The
fluid level must be within the HOT range of dipstick.
− Reinstall the dipstick into the transaxle.
• With the X-431 scan tool, read TCM DTCs.
• Refer to DTC Confirmation Procedure .
Is DTC 46 present?
Yes >>
Replace the TCM.
No >>
The system is now operating properly.
Chery Automobile Co., Ltd.
DIAGNOSIS & TESTING
08
235
08–