Check Output Shaft Speed Sensor Power Supply - Chery Tiggo 2009 Service Manual

Diagnostic Procedure
1.
CHECK A/T OUTPUT SIGNAL
• With the scan tool, select view DTC and data stream for A/T.
• Vehicle start and read out the value of OUTPUT SPEED SENSOR .
ITEM CONDITION
Output speed
During driving
sensor
Is the check result normal?
Yes >>
The condition that caused this DTC is intermittent (See Diagnostic Help in Section 08 Transaxle &
Transfer Case).
No >>
Go to the next step.
2.

CHECK OUTPUT SHAFT SPEED SENSOR POWER SUPPLY

• Stop vehicle and turn ignition switch off.
• Disconnect output shaft speed sensor connector.
• Turn ignition switch on.
• Check sensor power supply between sensor termi-
nal 3 and ground in the sensor electrical connector
E-089.
• Voltage should be more than 12 V.
Is the check result normal?
Yes >>
Go to step 4.
No >>
Go to the next step.
170
08–
DIAGNOSIS & TESTING
DISPLAY
VALUE
Approximately
matches the
speedometer
reading.
Chery Automobile Co., Ltd.
LTSMD080006