F4A4 Automatic Transaxle On-Vehicle Service; F4A4 Automatic Transaxle Assembly Removal & Installation - Chery Tiggo 2009 Service Manual

F4A4 Automatic Transaxle Assembly
Removal & Installation
1. Raise and support the vehicle.
2. Disconnect the negative battery cable.
3. Remove the battery and battery tray (See Battery Removal & Installation in Section 05 Starting & Charging).
4. Remove the air cleaner and air duct assembly.
5. Drain the cooling system (See Cooling System Draining Procedure in Section 06 Cooling System).
6. Remove the base mounting bolts (1) of the air
cleaner housing assembly.
7. Disconnect and remove the electrical connectors
for the following components:
• Output shaft sensor (1)
• Input shaft sensor (2)
• Electromagnetic valve switch connector (3)
• Gear switch connector (5)
8. Disconnect the transaxle fluid lines (6) using a suit-
able tool.
9. Remove the shift cable (4) from the transaxle
assembly.
10. Remove the starter motor (See Starter Removal & Installation in Section 05 Starting & Charging).
240
08–
ON-VEHICLE SERVICE
Chery Automobile Co., Ltd.
BESM080038
LTSM080153