Transaxle Inspection - Chery Tiggo 2009 Service Manual

Inspection
1. Place a tin solder sheet (1) (approximate length is
10 mm and diameter is 1.6 mm) on the specified
part of the transaxle housing, and then install the
differential outer bearing race.
2. Install the clutch housing, and tighten the bolts to
the specified torque.
3. Replace the tin solder sheets with thicker tin solder
sheets.
4. With a micrometer, measure the thickness (T) of
the flattened tin solder sheet.
• Select the thickness of the shim to be installed
according to the following equation.
− Thickness of washer: (T + 0.005 mm) - (T +
0.11 mm)
5. Do not clean the release bearing.
6. Clean the sealing surface of all contaminates, remove all old sealant, and clean all bolt holes.
7. Check all parts for damage, replace any damaged parts if necessary.
8. Always align the bearing cap (1) with the shaft
opening. Align the bearing collar to the bearing cap
opening (as the two circular rings indicate in the
figure).
274
08–
MANUAL TRANSAXLE UNIT REPAIR
Chery Automobile Co., Ltd.
LTSM080026
LTSM080027
LTSM080131