Chery Tiggo 2009 Service Manual page 1172

5.
CHECK 2ND GEAR BRAKE SYSTEM
• Check 2nd gear brake system:
− Check 2nd gear brake plate
− Check 2nd gear brake disc
− Central support
− Snap ring
− Clutch reaction disc
− Spring retainer
− 2nd gear brake piston
Is the check result normal?
Yes >>
Go to the next step.
No >>
Replace the damaged components.
6.
CHECK OVERDRIVE CLUTCH SYSTEM
• Check overdrive clutch system:
− Check overdrive clutch plate
− Check overdrive clutch disc
− Central Support
− Snap Ring
− Clutch Reaction Disc
− Spring Retainer
− overdrive clutch piston
Is the check result normal?
Yes >>
Go to the next step.
No >>
Replace the damaged components.
7.
CHECK DTC
• Assemble all disassembled components.
• Install the transaxle assembly (See Automatic Transaxle Removal & Installation in Section 08 Transaxle &
Transfer Case).
• Fill the transaxle with new ATF:
− Fill the ATF from the fill tube.
− Reinstall the hose connector disassembled in step 1 and reinstall the dipstick (clean the dipstick before
installing).
− Shift the gear selector lever to each gear position and then shift to gear "N".
− Drive the vehicle until the ATF reaches operating temperature (70° - 80°C) and re-check the fluid level. The
fluid level must be within the HOT range of dipstick.
− Reinstall the dipstick into the transaxle.
− With the X-431 scan tool, read TCM DTCs.
− Refer to DTC Confirmation Procedure .
Is DTC 44 present?
Yes >>
Replace the TCM.
No >>
The system is now operating properly.
Chery Automobile Co., Ltd.
DIAGNOSIS & TESTING
08
229
08–