Check Left Rear Wheel Speed Sensor Electrical Connector; Check Left Rear Wheel Speed Sensor Reference Signal Circuit; Check Left Rear Wheel Speed Sensor Resistance - Chery Tiggo 2009 Service Manual

2.

CHECK LEFT REAR WHEEL SPEED SENSOR ELECTRICAL CONNECTOR

• Turn ignition switch off.
• Disconnect the wheel speed sensor (1) electrical connector.
• Inspect the wheel speed sensor electrical connector.
Is the electrical connector OK?
Yes >>
Go to the next step.
No >>
Repair or replace the electrical connector as necessary.
3.

CHECK LEFT REAR WHEEL SPEED SENSOR REFERENCE SIGNAL CIRCUIT

• Turn ignition switch on.
• Measure the sensor reference voltage between ter-
minal 2 of the wheel speed sensor connector, ter-
minal side and ground.
• Voltage should exist (2.0 - 4.0 V).
Is the proper voltage present?
Yes >>
Go to the next step.
No >>
Repair or replace the circuit for an open,
short to ground or short to battery in connector or
harness.
4.

CHECK LEFT REAR WHEEL SPEED SENSOR RESISTANCE

• Check the wheel speed sensor resistance between
the sensor terminals 1 and 2, component side.
Is the sensor resistance 700 - 1500 ohms?
Yes >>
Go to the next step.
No >>
Replace the Left Rear wheel speed
sensor.
Chery Automobile Co., Ltd.
DIAGNOSIS & TESTING
LTSMD120003
12
VISMD120005
67
12–