Chery Tiggo 2009 Service Manual page 1550

4.
CHECK DRIVER AIRBAG MODULE CONTROL CIRCUITS
WARNING!
To avoid serious or fatal injury, turn the ignition switch off, disconnect the negative battery cable and wait two
minutes before proceeding.
• Disconnect the driver airbag module connectors.
NOTE :
Check connectors - Clean and repair as necessary.
• Check the harness for continuity of the driver airbag circuit between terminal 1 in the driver airbag module elec-
trical connector J-003 and terminal 1 in the spiral cable electrical connector J-005 terminal side.
• Continuity should exist.
DRIVER
SPIRAL
AIRBAG
CABLE
MODULE
TERMINAL
TERMINAL
1 1
• Check the harness for continuity of the driver airbag circuit between the driver airbag module electrical connec-
tor terminal 2 and the spiral cable electrical connector terminal 2.
• Continuity should exist.
DRIVER
SPIRAL
AIRBAG
CABLE
MODULE
TERMINAL
TERMINAL
2 2
Is the check result normal?
Yes >>
Go to the next step.
No >>
Replace the spiral cable.
Chery Automobile Co., Ltd.
DIAGNOSIS & TESTING
CHECK CONTINUITY
CONTINUITY
Yes
CHECK CONTINUITY
CONTINUITY
Yes
14
21
14–