Check Left Rear Wheel Speed Sensor Ground Circuit For An Open; Check Left Rear Wheel Speed Sensor Ground Circuit For Short To Ground; Check Left Rear Wheel Speed Sensor Ground Circuit For Short To Voltage - Chery Tiggo 2009 Service Manual

5.

CHECK LEFT REAR WHEEL SPEED SENSOR GROUND CIRCUIT FOR AN OPEN

• Turn ignition switch off.
• Disconnect the ABS module electrical connector.
• For 1.6L/1.8L engine: Check the continuity between
terminal 6 of the ABS module connector E-002, and
terminal 2 of the Left Rear wheel speed sensor
connector B-021, terminal side.
• For 2.0L/2.4L engine: Check the continuity between
terminal 6 of the ABS module connector A-020, and
terminal 2 of the Left Rear wheel speed sensor
connector B-021, terminal side.
• Continuity should exist.
Is the check result normal?
Yes
>>
Go to the next step.
No >>
Repair or replace the circuit for an open.
6.
CHECK LEFT REAR WHEEL SPEED SENSOR GROUND CIRCUIT FOR A SHORT TO GROUND
• Check the continuity between terminal 2 of the Left Rear wheel speed sensor connector, terminal side and
ground.
• Continuity should not exist.
Is the check result normal?
Yes >>
Go to the next step.
No >>
Repair or replace the circuit for a short to ground.
7.
CHECK LEFT REAR WHEEL SPEED SENSOR GROUND CIRCUIT FOR A SHORT TO VOLTAGE
• Check the voltage between terminal 2 of the Left Rear wheel speed sensor connector, terminal side and
ground.
• Voltage should not exist.
Is the check result normal?
Yes >>
Go to the next step.
No >>
Repair or replace the circuit for a short to battery.
8.
CHECK DTC
• With the X-431 scan tool, read the ABS module DTCs.
• Refer to DTC Confirmation Procedure .
Is DTC C1206 present?
Yes >>
Replace the ABS module (See ABS Module Removal & Installation in Section 12 Brakes).
No >>
The system is now operating properly.
Erase all codes and test drive the vehicle to verify the repair is complete.
68
12–
DIAGNOSIS & TESTING
Chery Automobile Co., Ltd.
LTSMD120007