Interactive Torque Management (Itm) Controller Removal/Installation - Chery Tiggo 2009 Service Manual

Removal & Installation
1. Raise and support the vehicle.
2. Remove the front intermediate drive shaft (See Front Intermediate Drive Shaft Removal & Installation in Section
09 Driveline & Axle).
3. Remove the rear intermediate drive shaft (See Rear Intermediate Drive Shaft Removal & Installation in Section
09 Driveline & Axle).
4. Remove the ITM Controller electrical connector (1).
5. Remove the ITM Controller mounting bracket bolts
(1).
(Tighten: ITM Controller mounting bracket bolts to
60 ± 5 N·m)
6. Remove the ITM Controller assembly.
NOTE :
The ITM Controller assembly is a precision component, be careful to avoid dropping or mis-handling the ITM Con-
troller during removal.
7. Installation is in the reverse order of removal.
22
09–
ON-VEHICLE SERVICE
Chery Automobile Co., Ltd.
LTSM160022
LTSM160023