Check Front Passenger Airbag Module - Chery Tiggo 2009 Service Manual

Diagnostic Procedure
1.
CHECK RCM DTC
• With the scan tool X-431, view DTCs in the RCM.
Is DTC B1352 present?
Yes >>
Go to the next step.
No >>
Go to step 6.
2.

CHECK FRONT PASSENGER AIRBAG MODULE

• Turn ignition switch off.
• Disconnect the negative battery cable.
WARNING!
To avoid serious or fatal injury, turn ignition switch off, disconnect the negative battery cable and wait two min-
utes before proceeding.
• Disconnect the passenger airbag module electrical connector.
NOTE :
Check connectors - Clean and repair as necessary.
• Connect the airbag special load tool to the spiral cable side of the vehicle harness (connect the special tool
resistor (2 ) in place of the passenger airbag module).
• Connect the negative battery cable.
WARNING!
To avoid serious or fatal injury, the passenger airbag module should not be check by multimeter.
NOTE :
If the airbag special load tool is not available, connect a known good passenger airbag module.
WARNING!
To avoid serious or fatal injury, reconnect the battery, then turn ignition switch on.
• Turn ignition switch on.
• With the scan tool, erase the DTC memory.
• Turn ignition switch off, and wait a few seconds, then turn ignition switch on.
• With the scan tool, read the RCM DTCs
Is DTC B1352 present?
Yes >>
Go to the next step.
No >>
Replace the passenger airbag module (See Passenger Airbag Module Removal & Installation in Sec-
tion 14 Restraints).
Reassemble the vehicle and road test to verify the customers complaint is repaired.
3.
CHECK PASSENGER AIRBAG MODULE CONTROL CIRCUITS
WARNING!
To avoid serious or fatal injury, turn ignition switch off, disconnect the negative battery cable and wait two min-
utes before proceeding.
26
14–
DIAGNOSIS & TESTING
Chery Automobile Co., Ltd.