Chery Tiggo 2009 Service Manual page 1231

NOTE :
The following special tools are required to perform the repair procedure:
• MB-998801 - Bearing Remover
• MB-998812 - Installer Cap
• MB-998814 - Installer Connector (200 mm)
• MB-998813 - Installer (100)
• MB-998818 - Installer Connector (38 mm)
• MB-998819 - Installer Connector (40 mm)
• MB-998822 - Installer Connector (46 mm)
• MB-998825 - Installer Connector (52 mm)
1. Using special tool MB-998917 (2), disassemble the
output shaft rear bearing (1).
2. Disassemble the reverse gear sleeve (1).
Install special tool MB-998801 (2) on the reverse
driven gear, and then disassemble the sleeve.
3. Disassemble the 5th-reverse gear synchronizer
hub (1).
Install special tool MB-998801 (2) on the 4th driven
gear, and then disassemble the gear hub-5th-re-
verse gear.
288
08–
MANUAL TRANSAXLE UNIT REPAIR
Chery Automobile Co., Ltd.
LTSM080061
LTSM080062
LTSM080063