Parking Brake On-Vehicle Service; Parking Brake Lever Removal & Installation - Chery Tiggo 2009 Service Manual

Parking Brake Lever
Removal & Installation
1. Block the tire and wheel assemblies so the vehicle does not move once the vehicle parking brake lever is
released.
2. Remove the center console (See Center Console Removal & Installation in Section 15 Body & Accessories).
3. Loosen the adjusting nut (2) on the lever's output
cable, taking tension off parking brake cables.
4. Back the nut off until it is flush with the end of the
output cable.
5. Remove the bolts (1) attaching the parking brake
lever to the vehicle.
(Tighten: Parking brake lever bolts to 30 N·m)
6. Remove the parking brake assembly.
7. Installation is in the reverse order of removal.
Installation Notes:
• After installation, adjust the parking brake cable as necessary (See Parking Brake Adjustment in Section 12
Brakes).
84
12–
ON-VEHICLE SERVICE
Chery Automobile Co., Ltd.
LTSM120031