Separation Of Interior Transmission Parts And Fork Module From The Housing - Chery QQ6 Service Manual

Transmission housing Clutch housing
Figure 5

6. Separation of interior transmission parts and fork module from the housing

After transmission housing and clutch housing are separated, keep the clutch housing flat at the place as
shown in Figure 6, remove the bolts for bracket of reverse gear rocker arm, take out the reverse gear rocker
arm assembly and the pin on idler drive, and then take out input shaft, output shaft and fork mechanism
together (when taking out, gently shake, meanwhile, press the driven gear of main decelerator along the
direction of arrowhead as shown in the figure to take out the assembly of input shaft, output shaft and idler
as well as fork mechanism); when taking out, remember to avoid interference between bearing retainer of
output shaft and big gear ring of differential and prevent the bearing retainer from damage.
Bolts for reverse gear rocker arm bracket (2 in total)
Reverse gear idler assembly
Reverse gear rocker arm
Figure 6
11