Alignment Of The Rear Wheel - Chery automobile Service Manual

------Measure the height from the wheel center to the mudguard edge. The measured
difference from left and right should be not more than 10mm.

ALIGNMENT OF THE REAR WHEEL

It is recommended to utilize the four-wheel alignment tester with thrust line positioning
method on this type of chassis.
Note: thrust line positioning is defined as adjusting the front wheel toe-in based on the
rear wheel thrust line.
With the thrust line positioning, the adjustment of the rear wheel toe-in will influence the
single front wheel toe-in, so during four-wheel alignment, the rear wheel should be adjusted
before the front wheel alignment.
Measure the vehicle height
------Rear measure point
From ground to the center of the joint bolt of
the rear axle and the body (as the arrow
shows)
Precaution: Check whether the height from
left and right are same before processing
the wheel alignment
------If there is a difference of the heights from
left and right, that means there are
damaged or deformed components of the
front and rear suspension.
Install the wheel alignment tester on wheel
------Please refer to the specific instruction of
manufacturer for the wheel alignment
tester.
M-9