Belt Full Detection - Oce TDS860 User Manual

Adjust the punch unit
Open the front door of the high capacity output unit of the folder.
1
Turn the black knob to adjust the folding width (see figure 127). Refer to the
2
sticker inside the unit.
[127] Knob to adjust the folding width in the punch unit
Loosen the screw and place the plate according to the folding length (see
3
figure 128).
[128] Nut to adjust the folding length in the punch unit
Tighten the screw.
4

Belt full detection

The Océ TDS800 has a belt full detection on both belts. The attention light on
the printer operator panel will go on if the belt is full. The system can switch
belts when the first belt is full. You can set after how many jobs the belt is full.
The folder 235