Oce TDS860 User Manual page 240

Use both hands to put the holder in the paper roll compartment. First, position
7
the left hand side of the holder in its notch, then position the right hand side in
its notch (see figure 132).
[132] Put the roll into the paper roll compartment
If the new roll does not have a straight leading strip you can cut it manually.
8
Press the correct button inside the paper roll compartment and feed the paper
9
between the input guide plates as indicated by the arrow (see figure 133). The
material is fed into the machine.
Also see the stickers inside the roll compartments on how to feed
Note:
paper.
[133] Button to feed the paper
Close the paper roll compartment. The material is cut. The size of material is
10
indicated on the operator panel.
If you have loaded another media type, you have to define the type
Note:
(see 'Define the media type' on page 242).
240 Océ TDS860 User Manual