How To Retrieve Scanned Files - Oce TDS860 User Manual

How to retrieve scanned files

When you scan-to-file your files will be stored in the destination you set. This
can be on the local controller or on a remote system. You can retrieve your files
from the local controller via File Transfer Protocol (FTP) (see figure 69). Also
if during scanning to a remote destination something goes wrong, you can
retrieve your files from the local controller.
Files scanned to a local destination are stored in the directory of the controller.
You can retrieve your files from the local host via File Transfer Protocol (FTP).
FTP can be done:
via an internet browser
1
an FTP application, or
2
via a command line prompt.
3
[69] How to retrieve scan files
Retrieve files via an FTP command line promp
Launch an FTP client.
1
Enter the 'ftp' command.
2
A DOS box now appears with the FTP prompt.
Enter the 'Open' command followed by either the registered name of the Océ
3
Power Logic® Controller or the IP address (for example: 194.2.66.146) to
connect to the Controller and press Enter: 'open 194.2.66.146'.
Using the Océ TDS860 to scan-to-file
t
129