Find System Settings In The Settings Editor - Oce TDS860 User Manual

Enter the filename without .kos or .sas.
2
Click the 'Save' button.
3
all settings, key operator and system administrator included, are saved.
Note:
How to load KO or SA settings from a file
From the 'File' menu, select 'Open'.
1
You can also click the 'Open' button on the top toolbar.
The screen displays a dialog box from where you can browse to the required
file.
Click the 'Apply' button.
2
The settings are loaded to the system.
When you are logged on as a key operator, the system only loads the KO
settings.
When you are logged on as a system administrator, the system only loads the
SA settings.
Repro operators and anonymous users are not authorised to load the settings
from a file.
this is only possible if the user is logged in as a Key Operator or System
Note:
Administrator.

Find system settings in the Settings Editor

The following table displays all references in this manual that refer to a
Settings Editor setting. KO indicate that you must have Key Operator
permission to change the setting. SA indicates that you must have System
Administrator permission to change the setting. Open the 'File' menu and
select 'Logon' to logon as Key Operator or as System Administrator (see
Figure 102 on page 177).
System setting
Low power mode timer
Sleep mode timer
Shut off timer
Wake up timer
Océ Power Logic®: Settings Editor
Reference Path in Settings Editor
on
page 26 KO - System - Timers - Sleep mode
timer enable - Low power mode time-
out
page 26 KO - System - Timers - Sleep mode
timer
KO - System - Timers - Sleep mode
timer enable
page 26 KO - System - Timers - Shut-off time
out
page 26 KO - System - Wake up
187