Make Copies - Oce TDS860 User Manual

Make copies

Place your original face-down, right aligned along the original guide. Keep the
1
legend at your right hand side.
When you feed the original, keep it in place until it is transported
Note:
(about 1 cm) into the machine.
[34] Inserting the original
Specify the number of copies using the numeric keys.
2
Specify the 'Paper series' on the 'Sheet' card in the 'Original' section.
3
The Océ TDS600 scanner supports both DIN and ANSI media
Note:
formats.
Specify the desired media on the operator panel.
4
If you select 'Automatic', the Océ TDS600 scanner will use a zoom factor that
is needed to obtain a copy without loss of information. After inserting the
original, the zoom factor that is used is indicated by the ' ' symbol.
The zoom factor is based on the selected media size
Note:
Use the 'Media' function to select copy material and format.
Specify how a job will be sorted: 'Single sheet', 'Multiple sheets' (output: 1-1,
5
2-2, 3-3) or 'Set'(output: 1-2-3, 1-2-3).
The currently selected input mode is indicated by the '
Specify a reduction or enlargement factor on the operator panel by using the
6
'Zoom' function.
If you select 'Automatic', the Océ TDS600 scanner will use a zoom factor that
is needed to obtain a copy without loss of information. After inserting the
original, the zoom factor that is used is indicated by the '
The zoom factor is based on the selected media size.
Note:
Specify the desired brightness on the operator panel.
7
You can use the 'Brightness' setting to correct for a lighter or darker original.
Using the Océ TDS600 scanner to copy
' symbol.
l
' symbol.
m
87