Using The Manual Feed For Copying - Oce TDS860 User Manual

Using the manual feed for copying

If you want to copy a job on a media type or size that is not available on one of
the paper rolls or sheet feeders, it can be convenient to manually feed sheets
instead of switching paper rolls or sheet feeders. The sheet feed is a special slot
just above the roll drawers on the engine. You can insert pre-cut copy material
into this slot, one sheet at a time.
Only use media as specified in '' on page 301.
Note:
Copying on pre-cut sheets
Open the 'Sheet' card in the 'Print' section.
1
Press the 'Manual feed' key. The display will look as follows:
2
[44] Using the manual feed option
Select any other required settings.
3
Enter the number of copies using the numeric keys.
4
Feed the original.
5
Press the start key.
6
Take your sheet of copy material to the side of the printer engine that contains
7
the sheet feed.
Use both hands to align the copy material in accordance with the format
8
indication and the sticker on the manual feed table.
Move the copy material forward in the nip of the roller. This must cause an
9
ample paper bulge over the full width of the page.
Hold the paper with both hands until the engine pulls in the first part of the
10
sheet.
The bulge will be reduced or it will disappear. A few seconds later the complete
sheet will be pulled into the printer.
If the copy job requires more sheets, the display will ask you to feed
Note:
the next sheet.
96 Océ TDS860 User Manual