Stopping A Job - Oce TDS860 User Manual

Copying on pre-cut sheets
Press the Manual feed key on the Scanner.
1
Select any other required settings.
2
Enter the number of copies using the numeric keys.
3
Feed the original. The printer display looks as follows:
4
[25] The printer operator panel with manual feed message
Press the start key.
5
Take your sheet of copy material to the side of the printer engine that contains
6
the Manual feed.
Use both hands to align the copy material in accordance with the format
7
indication and the sticker on the manual feed table.
Move the copy material forward in the nip of the roller. This must cause an
8
ample paper bulge over the full width of the page.
Hold the paper with both hands until the engine pulls in the first part of the
9
sheet.
The bulge will be reduced or it will disappear. A few seconds later the complete
sheet will be pulled into the printer.
If the copy job requires more sheets, the display will ask you to feed
Note:
the next sheet.
Repeat steps 7 to 11 to complete the job.
10
Collect your output.
11

Stopping a job

Pressing the Stop key interrupts the original transport.
How to stop a job
Press the Stop key.
1
The original transport is now stopped and you are prompted to open the
scanner cover in order to remove the original.
Open the cover.
2
Remove the original.
3
Close the cover.
4
You are now ready to start the next copy job.
68 Océ TDS860 User Manual