Change The Operator Panel Language; Settings On The Océ Tds800 Scanner Operator Panel - Oce TDS860 User Manual

Change the operator panel language

It is possible to change the operator panel language. You can choose between
two preferred languages. Define the first and second language on the Océ
Settings Editor (see 'Find system settings in the Settings Editor' on page 187).
The Océ TDS860 supports a total of 17 languages. See chapter 7, 'Océ Power
Logic®: Settings Editor' on page 173 and the On-line Help on the Océ Settings
Editor.
How to select a language
Open the 'Scanner' card in the 'Original' section.
1
Press the 'Language' function key to set the needed language.
2
Settings on the Océ TDS800 scanner operator panel
When job templates are enabled in the Océ Settings Editor, the job templates
are displayed on start-up of the Océ TDS800 scanner (see Figure 12 on
page 53). When job templates are not enabled in the Océ Settings Editor, the
'Custom' section is displayed on start up (see Figure 13 on page 54).
The custom section
Editor. This contains a number of settings which are direct accessible. The key
operator defines the custom section in the Océ Settings Editor
How to make settings
Select a template (only applies when job templates on the scanner operator
1
panel are enabled in the Océ Settings Editor).
Press one of the Section keys to activate the desired menu.
2
The active menu is slightly moved downwards to visually separate it
Note:
from the other menus. Apart from that, a shadow highlighting effect is used
for extra highlighting.
Press the Selection key to select the appropriate card. You can switch cards
3
(from bottom to top) by pressing the key again.
Here, too, the active card is visually separated from the other cards
Note:
and given a shadow highlighting effect for extra highlighting.
58 Océ TDS860 User Manual
gives access to the settings you defined in Océ Settings