Oce TDS860 User Manual page 155

Select default settings for auto shifting with standard cut option
You must enable standard cut length to get output like the one in the example
of illustration 92 above. With 'Standard cut' the print length corresponds to a
standard format, depending on the media width. When you use 'Standard cut'
information loss can occur.
Open the 'Layout' card in the 'Copy' section.
1
[93] Automatic shift with the
Press the 'Align' function key and select a horizontal alignment value (Left,
2
Middle or Right) with the Arrow keys.
Press the 'Align' function key again and select a vertical alignment value (Top,
3
Middle, or Bottom) with the Arrow keys.
If you select 'Middle', make sure the original width is properly
Note:
specified as described in the section about 'The scan width' on page 136:
'Standard' if a standard sized original is used
The exact original width (numeric) if a non-standard sized original is used.
Feed your original.
4
You must enable synchro cut length to get output like the one in the example
of illustration 61. With 'Synchro cut' the system cuts at the measured length of
the original times the zoom factor. The minimum length is 279 mm or 11 inch.
When you use 'Synchro cut' information loss will not occur.
Special copy and scan jobs
' '
Align function
155