Oce TDS860 User Manual page 59

Select the desired function values in one of the following ways:
4
Simple (non-numeric) selection: press the Function key to activate the
desired (non-numeric) value. The selected value is preceded by a ' ' symbol.
Long list selection: if you want to select a value from a list of options that
cannot be fully displayed on the panel, you first activate the selection
triangles next to the specified option (the dotted line around this selection is
changed into an uninterrupted line and the selection triangles are no longer
dimmed), which indicate that there are additional options available and then
select one of the non-displayed values with the 'Arrow' keys. The 'Original
type' setting demonstrated in figure 15 on page 55 is an example of this.
Numeric selection: activate the selection triangles and select the desired
value with the 'Arrow' keys or with the numeric keys.
Also a combination of simple selection and numeric selection is possible.
The Correction key
use the Correction key to do the following:
Press the Correction key one time to return to the default value of the active
1
setting.
Press the Correction key two times to set the numeric display to 1.
2
Press the Correction key three times to return to the top layer of the Scanner
3
Operator Panel. When job templates are enabled in the Océ Settings Editor, the
top layer shows the job templates. When job templates are not enabled in the
Océ Settings Editor, the top layer shows the 'Custom' section.
When 'Automatic feed' is selected for a single sheet job, this setting stays
active.
Job interrupt only stays active for one job. You have to press the Job interrupt
key before each new job you want to give interrupt priority.
The Scanner Operator Panel will automatically return to the top layer and the
default settings after the time defined in the 'Panel Time-out' setting in the Océ
Settings Editor (see 'Find system settings in the Settings Editor' on page 187).
Using the Océ TDS800 scanner to copy 59