Scanning Originals With Filing Strip - Oce TDS860 User Manual

Scanning originals with filing strip

Left hand side
filing strip along the left hand side (in the feed direction, face-up). This side
can be reduced by up to 60 mm (see figure 76).
[76] Example of adjusting the left hand side of an original
Copying with removed filing strip along the left hand side
Press the handle underneath the original guide, and move it to the right.
1
[77] Adjusting the original guide to add or remove a filing strip along the left hand side
Make all required settings.
2
Insert the original face up, left aligned with the original guide on the original
3
feed table.
Right hand side
(in the feed direction, face-up) by selecting a specific roll. If the paper width
of the original is larger than the paper width of the selected roll, the remaining
part on the right hand side will not be scanned.
138 Océ TDS860 User Manual
You can adjust the original guide of the scanner to remove a
Left hand side
- 40 mm
You can also remove the filing strip along the right hand side
Left hand side
+20 mm