File Mode; Destination - Oce TDS860 User Manual

File mode

File mode can be 'Off', 'On' or 'On with checkprint'. 'Off' means scan-to-file
is not active. 'On' means scan-to-file is active. To scan to file with a checkprint,
activate both the file mode and the print mode on the scanner operator panel.
The checkprint quality corresponds to the scan resolution. A checkprint is a
print of the scanned original, ensuring consistency with a later print of the
scanned file.
How to scan to file with checkprint
Press the section key above the File section two times
1
The File mode is switched on
Press the section key above the Print section two times
2
The Print mode is switched on
The system is now ready to scan-to-file with checkprint.
3
The Océ TDS860 system does not allow you to change the 'File mode'
Note:
setting during a set from 'On' to 'Off' and the other way around. However,
changing from 'On' to 'On with checkprint' and vice versa is allowed.
In scan-to-file mode the automatic behavior is optimized for scanning.
Note:
Turning checkprint on or off does not influence this automatic behavior.

Destination

You can store your scan either in the temporary store on the controller or on a
network destination. You can define up to ten destinations in the Océ Scan
Manager application. Select the destinations defined in Océ Scan Manager on
the scanner operator panel. You can only select one destination at a time.
Select a destination
Press the function key to select destination.
1
Define the names of the destinations in Océ Scan Manager (see 'Create
Note:
a local destination' on page 121).
114 Océ TDS860 User Manual