Overview; Enabling The Ports And Setting The Ip Addresses - Xerox 4590 System Administration Manual

Overview

Enabling the ports and setting the IP addresses

X er o x 4 5 90 / 4110 C o pi e r /P r i n te r S y s t em A d m i ni s tr at i on G u i d e
This section describes the configuration procedure to use the
scanner (save to a computer) function on the machine.
The following is the procedure to use the scanner (save to a
computer) function:
• Enabling the port and setting TCP/IP
Enable the FTP port or SMB port and set the machine's IP
address.
• Preparing a FTP folder or SMB folder
Create a folder for transmission destinations on the computer.
NOTE: When using with SMB protocol, you must login to the FTP
server of your choice and create a destination directory for your
files.
In order to use the scanner (save to a computer) service, enable a
port (SMB or FTP client) and set the IP address. The procedure
for setting the machine is as follows:
NOTE 1: The configuration can also be performed using
CentreWare Internet Services.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
Refer to "Using CentreWare Internet Services" on page 3-1.
Display the System Administrator Menu screen.
1.
a. Press the Log In/Out button.
NOTE: If the password is set, the Login screen is
displayed.
b. If the password is set, enter the password using the
numeric keypad and select Confirm. If the password is not
set, proceed to step c.
NOTE: The default value for the password is 11111.
c. Select System Settings.
When using the SMB protocol, enable the SMB port.
2.
a. Select System Settings.
b. Select Network Settings.
c. Select Port Settings.
d. Select SMB and then select Change Settings.
5 . Us i n g th e S c a n Se r v i c e
5-21