Xerox 4590 System Administration Manual page 367

Cause
The print queue where the user
has transmitted the print data, is
not assigned to the machine.
Print data format and the print
environment settings on the
computer do not match.
The number of print queues set
for the machine exceeds the
maximum number of supported
queues on the machine.
The slave file server is not
configured. (Bindery Service
mode.)
Printer types do not match.
The slave file server configuration
is mismatched. (Bindery Service
mode.)
The form number on the print data
and the form number set to the
printer do not match.
The level settings for the IPX
checksum do not match.
X er o x 4 5 90 / 4110 C o pi e r /P r i n te r S y s t em A d m i ni s tr at i on G u i d e
Check point
Use NWADMIN from a computer
to check the print queue
Assignment to see if the machine
is in the printer list serviced by the
print queue.*
-
Use NWADMIN from a computer
to check the Assignment print
queue list on the machine to see if
the desirable print queue is
assigned to the machine.*
Use PCONSOLE from a computer
to confirm if the slave file server is
registered to the Service
NetWare Server on the print
server indicated by the Print
Server Information.*
Use PCONSOLE from a computer
to confirm if the printer type is set
to parallel, port is set to LPT1, and
location is set to automatic mode
(local) under Print Server
Information/Printer/Printer xxx
Environment Configuration.*
Use PCONSOLE from a computer
to confirm if the printer type is set
to Defined Elsewhere under
Print Server
Information/Printer/Printer xxx
Environment Configuration.*
Use NWADMIN on a computer to
select the machine and confirm
that the start number of the form
in the environment setting
matches the number in the print
data.*
Use the "set" command from the
console screen on the file server
confirm whether the IPX
checksum is set to level 2.
9 . Tr ou b le s h oo ti n g
Remedy
• Re-transmit the print data to
the print queue which is
assigned to the machine.*
• Use NWADMIN from a
computer to add the print
queue to the machine.*
If the computer is running
Windows, ensure that it is set to
not output Ctrl-"D."
Re-transmit the print data to the
print queue which is assigned to
the machine.*
Use PCONSOLE from a computer
to register the slave file server
and propagate the configuration
parameters.
Use PCONSOLE from a computer
to set the printer type to parallel,
port to LPT1, location to automatic
mode (local), and propagate the
configuration parameters.*
If not set to Defined Elsewhere,
change to Defined Elsewhere
and propagate the configuration
parameter.*
Use NWADMIN from a computer
to match the Start Form number
in the machine's environment
setting to the number in the print
data.*
Enter following command on
console screen in file server and
then set IPX checksum level 0 or
1:
set Enable IPX Checksum=x (x =
0 or 1)
9-7