Xerox 4590 System Administration Manual page 284

8. S e tu ps
PostScript Memory
HP-GL/2 Auto Layout
Memory
Receiving Buffer - LPD
Receiving Buffer - NetWare
Receiving Buffer - SMB
8- 1 2 6
screen.
NOTE 1: When a port is set to Disabled, the corresponding
items that are associated with that port do not appear.
NOTE 2: Depending on the amount of data sent from the
client, increasing the memory capacity may not change the
amount of time that it takes to release the client.
Specify the memory capacity used for PostScript. Set a value
from 8.00-96.00 MB, in 0.25 MB increments.
Specify the memory capacity used for HP-GL/2. Set a value from
64-5120 KB, in 32 KB increments.
NOTE: The maximum value that can be set for both the PostScript
Memory and HP-GL/2 Auto Layout Memory options vary
according to the available memory capacity.
• Off: When Off is selected, the machine will not use spooling.
During the LPD print process for one client, data cannot be
Spool
received over that same interface from a different client. Set a
value for the dedicated LPD receiving buffer memory capacity
from 1024-2048 KB, in 32 KB increments.
• Memory Spool: When selected, the machine will use
spooling. The receiving buffer for spooling uses memory.
When this candidate value is selected, set the memory
capacity of the receiving buffer for spooling, from 0.50 MB to
32.00 MB, in 0.25 MB increments.
NOTE: Notice that print data exceeding the set memory
capacity is not accepted. In such cases, select Hard Disk or
Off.
• Hard Disk Spool: When selected, the machine will use
spooling. The receiving buffer for spooling uses the hard disk.
Set the NetWare receiving buffer. Set a value from 64 to 1024 KB,
in 32 KB increments.
• Off: When Off is selected, the machine will not use spooling.
While SMB print processing is being carried out for one client,
Spool
data cannot be received over the same interface from another
client.
Set a value for the dedicated SMB receiving buffer memory
capacity from 64 to 1024 KB, in 32 KB increments.
• Memory Spool: When selected, the machine will use
spooling. The receiving buffer for spooling uses memory.
When this candidate value is selected, set the memory
capacity of the receiving buffer for spooling from 0.50 MB to
32.00 MB, in 0.25 MB increments.
Xe r o x 45 90 / 4110 Co p ie r / P r in t er S y s te m Ad m i ni s t r at i on G ui d e