Xerox 4590 System Administration Manual page 45

X er o x 4 5 90 / 4110 C o pi e r /P r i n te r S y s t em A d m i ni s tr at i on G u i d e
e. Select TCP/IP - Get IP Address and select Change
Settings.
f. Enter the IP address using the numeric keypad.
NOTE 1: Enter address in the format "xxx.xxx.xxx.xxx" where
xxx should be a numeric value in the range from 0 to 255.
However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot
be used.
NOTE 2: When you make an entry mistake, press the C
(Clear) button and enter again.
NOTE 3: When you would like to move to the next value
without entering all 3 digits, select Next.
g. Select Save.
h. Configure TCP/IP - Subnet Mask and TCP/IP - Gateway
Address as shown above.
NOTE 1: Enter address in the format "xxx.xxx.xxx.xxx" where
xxx should be a numeric value in the range from 0 to 255.
However, 224 or 225.xxx.xxx.xxx and 127.xxx.xxx.xxx cannot
be used.
NOTE 2: Specify the subnet mask by a combination of the
numbers 0, 128, 192, 224, 248, 252, and 255. However, you
cannot use 0 between non-zero values.
NOTE 3: If you do not wish to set the gateway address, enter
"0.0.0.0."
Select Close repeatedly until the System Settings screen is
4.
displayed.
Select Exit.
5.
After the machine is restarted, print out the Printer Settings
6.
List to confirm that the IPP port is enabled.
Configure the IPP as necessary. Refer to "IPP" on page 3-18 for
the IPP configuration.
2. Co n fi g ur a ti o n
2-11