Xerox 4590 System Administration Manual page 263

Pseudo-Photo Gradation
Original Type - Lightweight
Originals
Output Orientation-Reverse
Output Orientation-Auto
(Single sheet)
Stamp Density
X er o x 4 5 90 / 4110 C o pi e r /P r i n te r S y s t em A d m i ni s tr at i on G u i d e
Use the following procedure to select a default fine tune setting.
Select Fine-tune 100%, and select Change Settings.
1.
Enter the desired fine-tune value by using s, t,
2.
Select Save to save the changes and return to the Copy
3.
Control screen.
Select the default toning method for photo originals. To obtain an
image quality that is closer to the photo image, select how gray
Mode
tones will be handled by the machine. Select either Error
Diffusion or Dither.
Select the default setting for light weight originals. The selection
made here is displayed on the Image Quality screen, Original
Type feature. Select either Enabled or Disabled.
Select whether or not Reverse Order is enabled for the delivery of
the copy or print output. If Enabled is selected, Face Up,
Order
Reverse Order is displayed on the Output Orientation screen
(Output Format tab).
Select the default setting for delivering the copy or print
output. This default setting is displayed on the Output
Orientation screen (Output Format tab). Select either Face Up
or Face Down. The setting selected here is the default delivery
method when the Auto feature is selected on the Output
Orientation screen (Output Format tab).
Select the default translucency/density of the stamp when it is
printed out the copy/print output. Select from three translucency
values: 0% (solid), 25%, or 50%.
NOTE: Selecting the 0% value represents no translucency
(transparency); therefore, any text that resides underneath the
stamp may not be readable on the output.
8 . S e t ups
, and .
8-105