X er o x 4 5 90 / 4110 C o pi e r /P r i n te r S y s t em A d m i ni s tr at i on G u i d e
NOTE 1: Enter address in the format "xxx.xxx.xxx.xxx"
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.
NOTE 2: When you make an entry mistake, press the C
(Clear) button and enter again.
NOTE 3: When you would like to move to the next value
without entering all 3 digits, select Save/Select Next.
–
SMTP Server - Server Name
Enter if Specify by the Server Name has been
selected for SMTP Server - Setup.
–
SMTP Server - Port Number
Enter a value in the range from 1 to 65535.
NOTE: This configuration is not necessary if SMTP has
been selected for the Mail Receiving Protocol and has
already been configured.
–
E-mail Send Authentication
Select one from Off, POP before SMTP, or SMTP
AUTH.
NOTE: If POP before SMTP has been selected, the POP3
settings must be set.
–
SMTP AUTH - Login Name
Set this item if SMTP AUTH has been selected for E-
mail Send Authentication.
–
SMTP AUTH - Password
Set this item if SMTP AUTH has been selected for E-
mail Send Authentication. Enter the same password
twice in the New Password and Confirm
Password. If you do not wish to set the password,
leave it blank and select Save.
•
Select Close.
5 . Us i n g th e S c a n Se r v i c e
5-7