Table 39: T4000 Chassis Alarm Messages For Sibs - Juniper T4000 Hardware Manual

T4000 Router Hardware Guide
Solution
210
The green LED on the SIB faceplate is not lit.
OK
In Table 39 on page 210 the text in the column labeled "LCD Message" appears in the
display of the craft interface. The text in the column labeled "CLI Message" appears in
the output from the
show chassis alarms

Table 39: T4000 Chassis Alarm Messages for SIBs

Alarm Type LCD Message
Red
SIB sib-number Failure
SIB sib-number Removed
To troubleshoot the T4000 SIBs:
Check the LEDs on the faceplate of each SIB.
1.
Check the LEDs on the craft interface.
2.
Use the CLI to check for alarms.
3.
Issue the show chassis alarms
Use the
4. show chassis sibs
user@host> show chassis sibs
Slot State
0 Spare
1 Online
2 Online
3 Online
4 Online
Use the show chassis fabric sibs
5.
user@host> show chassis fabric sibs
Fabric management SIB state:
SIB #0
plane state: S_SPARE
FPC #4
PFE #0 : Links ok
PFE #1 : Links ok
FPC #6
PFE #0 : Links ok
PFE #1 : Links ok
FPC #7
PFE #0 : Links ok
PFE #1 : Links ok
SIB #1
plane state: S_ACTIVE
FPC #4
PFE #0 : Links ok
PFE #1 : Links ok
command.
CLI Message
SIB sib-number Fault
SIB sib-number Absent
command to view the alarms.
command.
Uptime
1 day, 14 hours, 21 minutes, 52 seconds
1 day, 14 hours, 21 minutes, 36 seconds
1 day, 14 hours, 21 minutes, 19 seconds
1 day, 14 hours, 21 minutes, 3 seconds
command.
Copyright © 2013, Juniper Networks, Inc.