Removing A Solid-State Disk From A T4000 Re-C1800 Routing Engine; Figure 130: Removing An Ssd - Juniper T4000 Hardware Manual

T4000 Router Hardware Guide

Removing a Solid-State Disk from a T4000 RE-C1800 Routing Engine

274
The solid-state disk (SSD) is located in the slot labeled
faceplate.
NOTE: The
DISK2
To remove an SSD from a Routing Engine (see
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Verify that the ,
2. Online DISK1
are off.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
3.
the strap to one of the ESD points on the chassis.
Using a Phillips (+) screwdriver, number 2, loosen the captive screws on the corners
4.
of the cover.
Remove the cover from the Routing Engine slots.
5.
CAUTION: Do not remove the cover if any of the LEDs on the Routing
Engine faceplate are lit.
Press the eject button on the right side of the
6.
The SSD pops partially out of the slot. Grasp the SSD and carefully slide it completely
7.
out of the slot.
Place the SSD on the antistatic mat.
8.

Figure 130: Removing an SSD

slot is not currently supported.
Figure 130 on page
, and LEDs on the backup Routing Engine faceplate
CF
slot to release the SSD.
DISK1
Copyright © 2013, Juniper Networks, Inc.
DISK1 on the Routing Engine
274):