Connecting The T4000 Router To An External Alarm-Reporting Device; Figure 65: Console And Auxiliary Ports On The Cip - Juniper T4000 Hardware Manual
Hide thumbs
Also See for T4000:
- Datasheet (4 pages) ,
- Hardware manual (468 pages) ,
- Quick start manual (40 pages)
Table of Contents
Advertisement
T4000 Router Hardware Guide
Related
Documentation
Connecting the T4000 Router to an External Alarm-Reporting Device
114
Figure 65: Console and Auxiliary Ports on the CIP
T4000 Connector Interface Panel (CIP) Description on page 27
Overview of Connecting the T4000 Router to External Devices on page 111
To connect the router to external alarm-reporting devices, attach wires to the
and
relay contacts on the CIP. A system condition that triggers the red
YELLOW ALARM
or yellow alarm LED on the craft interface also activates the corresponding alarm relay
contact.
The terminal blocks that plug into the alarm relay contacts are supplied with the router.
They accept wire of any gauge between 28 AWG and 14 AWG (0.08 and 2.08 mm
which is not provided. Use the gauge of wire appropriate for the external device you are
connecting.
RED ALARM
Copyright © 2013, Juniper Networks, Inc.
2
),
Advertisement
Table of Contents
Troubleshooting
