Reinstalling The T4000 Scgs; Figure 54: Reinstalling The Rear Fan Tray - Juniper T4000 Hardware Manual

Reinstalling the T4000 SCGs

Copyright © 2013, Juniper Networks, Inc.

Figure 54: Reinstalling the Rear Fan Tray

To reinstall the SCGs (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Carefully align the sides of the SCG with the guides in the SCG slot.
2.
Grasp the SCG by its handle, and slide it straight into the chassis until it contacts the
3.
midplane.
Tighten the captive screws on the corners of the SCG faceplate.
4.
Repeat the procedure to reinstall the remaining SCG.
5.
Chapter 10: Installing the T4000 Router Without a Mechanical Lift
Figure 55 on page 104):
103