T4000 Dc Power Requirements; Table 48: Typical Dc Power Requirements For T4000 Components - Juniper T4000 Hardware Manual

T4000 Router Hardware Guide

T4000 DC Power Requirements

338
T4000 DC Power Distribution on page 343
To allow for future growth so that you can operate the router in any hardware configuration
without upgrading the power infrastructure, we recommend that you provision 56 A @
–48 VDC per input for the 60-A DC power cables connected to each power supply.
Table 48 on page 338 lists the power requirements for various hardware components
when the router is operating under typical voltage conditions.
You can use the information in
Interface Module Reference
configurations, input current from a different source voltage, and thermal output, as
shown in the following examples for a DC-powered router.

Table 48: Typical DC Power Requirements for T4000 Components

Component
Base system, not including FPCs and PICs (includes five SIB-I-T4000 SIBs,
one host subsystem, one SCG, cooling system at normal speed, and craft
interface) and two power supplies
Base system, not including FPCs and PICs (includes five TXP-LCC-3D SIBs,
one host subsystem, one SCG, cooling system with FAN-R-TXP-3D-LCC rear
fan tray at normal speed, and craft interface) and two power supplies
SIB-I-T4000 SIB
TXP-LCC-3D SIB
T1600 Enhanced Scaling FPC4
T4000 FPC5
Line-card chassis control board (LCC-CB)
C1800 Routing Engine
SCG
Redundant backup six-input DC power supply
Cooling system with FAN-REAR-TXP-LCC (normal speed)
Cooling system with FAN-REAR-TXP-LCC (full speed)
Table 48 on page 338
to calculate power consumption for various hardware
and the PIC requirements in
Current
Requirement
(Amps @
–48 VDC)
30.8 A
31.0 A
4.7 A
4.2 A
11.3 A
13.6 A
1.0 A
1.7 A
0.2 A
5.2 A
8.2 A
23.6 A
Copyright © 2013, Juniper Networks, Inc.
T4000