Adding A New Ace To A Configured Acl; Mapping An Acl - 3Com WX4400 Reference Manual

238 C 6: C
HAPTER ONFIGURING
Adding a New ACE to
a Configured ACL

Mapping an ACL

WX S P
YSTEM ARAMETERS
To add a new ACE to a configured ACL:
1 Access the ACL table:
a Select the Configuration tool bar option.
b In the Organizer panel, click the plus sign next to the WX switch.
c Click the plus sign next to System.
d Select ACLs.
2 Select any ACE in the ACL to which you want to add the new ACE.
3 In the Task List panel, select Add Rules.
4 Go to step 3.
An ACL does not take effect until you map it to a user or an interface.
You can map ACLs to ports (or port groups), VLANs, or virtual ports. You
cannot map an ACL to a MAP port or a wired authentication port.
You also can map ACLs to user, by configuring the filter.in and filter.out
user attributes. User-based ACLs are more specific than ACLs applied to
interfaces and are therefore processed first. (See "Authorization
Attributes" on page 305.)
1 Access the ACL table:
a Select the Configuration tool bar option.
b In the Organizer panel, click the plus sign next to the WX switch.
c Click the plus sign next to System.
d Select ACLs.
2 Select any ACE in the ACL you want to map.
3 In the Task List panel, select ACL Mappings.
4 Select the mapping type:
To map to a physical port, select port and go to step 5.
To map to a virtual port, select vport and go to step 6.
To map to a VLAN, select vlan and go to step 7.
To map to a Distributed MAP, select dap and go to step 8.