Placing Installed And Auto-Configured Maps - 3Com WX4400 Reference Manual

142 C 5: P
HAPTER LANNING THE
Placing Installed
and
Auto-Configured
MAPs
3C M S
OM OBILITY YSTEM
You can place MAPs that are already installed on the floor into the
network plan. To do this, you upload the WX configuration into 3WXM,
associate the MAP with a coverage area, then place them on the floor
plan.
In addition, MAPs that receive their configuration using a profile are
automatically added to the network plan. They appear under Objects to
Place in the Organizer panel. From the Objects to Place panel, you can
place these MAPs onto the floor plan.
To place installed MAPs on the floor plan:
1 Select the Verification option in the main 3WXM tool bar, click the
Network Verification tab, and upload the MAP configuration into 3WXM.
(See "Verifying Configuration Changes" on page 377.)
2 Select the RF Planning option in the main 3WXM tool bar and display the
floor plan in the Content panel.
3 In the Coverage Areas section, right-click on the coverage area for which
the MAP is providing coverage, and select Edit Properties. The Coverage
Area Properties dialog appears.
4 Click the Associations tab.
5 Select the MAP in the Available Access Points group box and click the
Add button to move the MAP to the Current Access Points group box.
6 Click OK to save the changes and close the dialog box.
7 Click on Objects to Place in the Organizer panel.
8 Click on the MAP icon, then click on the location where you installed the
MAP. The MAP icon moves from the Objects To Place panel to its location
on the floor.