To Change Monitoring Settings - 3Com WX4400 Reference Manual

To change monitoring
settings
Table 39 Sources of Monitor Data (continued)
3WXM Client Display Data Source
Monitor tab — Clients Enable Client Session Collection option
Monitor tab — Traffic
Alarms (or Monitor
tab—Alarms)
Performance
Monitoring window
The monitoring options require SNMP traps to be enabled on the
monitored WX switches and also require 3WXM Services to be
configured as a notification target (trap receiver) for each of the switches.
The data for some reports also requires monitoring options to be
enabled. For information, see the descriptions for each report in
"Generating Reports" on page 417.
To change monitoring settings, use the following procedure.
1 Select Services > Setup or select the browser window if 3WXM Services
is already open. (See Figure on page 501.)
2 Select Setup, then select Monitoring Settings.
3 To change the number of minutes between status queries from 3WXM
Services to the WX switches it monitors, change the value in the Polling
interval box. You can specify from 1 to 60 minutes. The default is 5
minutes.
4 To change settings for monitoring of the log buffers on WX switches:
a Select Enable Log Monitoring. This option is enabled by default.
b To change the number of minutes between queries of the WX
switches' log buffers, change the value in the Polling interval box. You
can specify from 1 to 60 minutes. The default is 5 minutes.
c To change the maximum number of log entries 3WXM Services stores
for an individual WX switch, change the value in the entries per WX
box. You can specify from 1000 to 5000 entries, in increments of 100.
The default is 1000 entries.
Changing Monitoring Settings
Enable Traffic & RF Trending option
Enable Rogue Detection option, which
activates polling and uses SNMP traps received
by 3WXM Services from monitored WX
switches
Statistics data received by 3WXM Client
directly from managed WX switches. 3WXM
Services does not provide this data.
511
Default
Enabled
Enabled
Enabled
Enabled