3Com WX4400 Reference Manual page 258

258 C 7: C
HAPTER ONFIGURING
W P
IRELESS ARAMETERS
12 Click Next.
13 If you selected Static WEP in step 7, specify WEP keys. Otherwise, click
Next and go to step 15.
For each key (up to four), type the key value in the corresponding key
box.
By default, data in unicast and multicast packets are encrypted using
WEP key 1. To use another key for either type of packet, select the key
number in the WEP Unicast Key Index or WEP Multicast Key Index box.
14 Click Next.
15 Select or type the name of the VLAN to place clients in.
Clients are placed in this VLAN regardless of any other VLAN assignment.
For example, if the VLAN-Name attribute assigns the user to another
VLAN, the switch nonetheless places the user in the VLAN you specify
here.
16 Click Next.
The ACEs (ACL rules) that 3WXM will configure for the Web-Portal
service are listed. The ACEs are required to allow DHCP traffic while
blocking all other traffic while a user is being authenticated. These ACEs
are used only during authentication. After the user is authenticated, the
ACEs are not used.
If you need to add ACEs, use the following procedure. Otherwise, go to
step 17.
a Click Next.
b To add an ACE, click Add Rule. 3WXM adds an ACE to the end of the
list. The ACE matches on all source and destination IP addresses and
denies them.
To modify an ACE, select the part of the ACE you want to modify, and
edit or select the new value. (For information about ACE settings, see
"Viewing and Configuring ACLs" on page 230.)
CAUTION: Do not change the deny rule at the bottom of the ACL. This
rule must be present and the capture option must be used with the rule.
If the rule does not have the capture option, the Web Portal user never
receives a login page.
17 Click Next.
18 Specify the authentication method (RADIUS server group or local
database).