Creating Or Modifying Floors - 3Com WX4400 Reference Manual

82 C 5: P
HAPTER LANNING THE
Creating or
Modifying Floors
3C M S
OM OBILITY YSTEM
3WXM adjusts the default attenuations based on your selection.
10 To change the default attenuation for radios, type the number of dB in
the 802.11a (dB) box or 802.11b/g (dB) box.
From the Content panel of the building, you can edit the properties of
existing floors in the building. See "Creating or Modifying Floors" next
for more information.
To create or modify a floor in a building:
1 Select the RF Planning tool bar option.
2 In the Organizer panel, click the building name.
3 Do one of the following:
If you are creating a new floor, click on the building name in the
Organizer panel and select Create Floor in the Task List panel. A
series of dialog boxes prompts you for information about the new
floor.
If you are modifying an existing floor, select the floor name in the
Content panel for the building, then click Properties. A dialog box
allows you to edit the properties of the floor.
Click on the floor name in the Organizer panel, click on Floor in the
Task List panel, and then select Floor properties under Edit Floor.
The following figure illustrates the information displayed in the Floor
Properties dialog box for a floor. Note that this information is the same as
the information for which you are prompted when you create a floor.