Setting Up Ap Redundancy - 3Com WX4400 Reference Manual

286 C 7: C
HAPTER ONFIGURING
Setting Up AP
Redundancy
W P
IRELESS ARAMETERS
10 Configure the radios:
a To enable the radio, select Enabled.
b In the Radio Profile list, select the profile to which the radio belongs.
(For more information, see "Viewing and Configuring Radio Profiles"
on page 272.)
c In the Channel Number list, select the channel number for the radio.
If RF Auto-Tuning for channel configuration is enabled, setting this value
has no effect. The channel number is controlled by RF Auto-Tuning.
d In the Transmit Power box, specify the transmit power for the radio.
If RF Auto-Tuning for power configuration is enabled, setting this value
has no effect. The power level is controlled by RF Auto-Tuning.
e If the MAP has two radios, click Next and repeat this step for the
other radio. Otherwise, go to step 11.
11 Click Finish.
You can configure redundant WX connections for MAPs in the network.
Only AP models that have two Ethernet ports can support redundant
direct connections. However, models with one Ethernet port can support
redundant distributed connections.
WX4400 switches support indirect MAP connections only.
To set up AP redundancy:
1 Access the Setup AP Redundancy wizard:
a Select the Configuration tool bar option.
b In the Organizer panel, click the plus sign next to the WX switch.
c Click the plus sign next to Wireless.
d Select Access Points.
e In the Task List panel, select AP Redundancy.
The Setup AP redundancy wizard appears, listing the redundant
connections for each MP.
2 Select the MAP for which you want to set up a redundant WX connection
and click Add Connections.
a Under Select Bias, select either High or Low from the drop-down list.