Changing Default Radius Settings - 3Com WX4400 Reference Manual

Changing Default
RADIUS Settings
6 To reorder the servers, select a server and click Up or Down.
If load balancing is enabled, the first AAA request goes to the first
RADIUS server in the list. The second AAA request goes to the second
RADIUS server in the list, and so on, until the end of the list is reached,
after which the first server in the list is used again. Any server that does
not respond is skipped. If none of the servers responds, the WX goes to
the next method in the method list.
7 Click Next.
When you add a RADIUS server to a RADIUS server group, all RADIUS
timers for the server group are restarted.
You can set default values for certain RADIUS parameters that apply to
RADIUS servers and server groups you create for an individual WX. The
following RADIUS parameters, except system IP address, are defined with
default values, which you can change:
Timeout (generally set for only troubleshooting purposes)
Retry count (generally set for only troubleshooting purposes)
Dead time
Key
Authorization password
Use of the system IP address for the WX switch as the source address
for RADIUS packets from the switch
When you create a new RADIUS server, the default settings apply to the
new server.
To change default values for RADIUS parameters
1 Access the RADIUS defaults:
a Select the Configuration tool bar option.
b In the Organizer panel, click the plus sign next to the WX switch.
c Click the plus sign next to AAA.
d Select RADIUS.
e In the Task List panel, select RADIUS Defaults.
Viewing and Configuring RADIUS Settings 315