3Com WX4400 Reference Manual page 283

c Click the plus sign next to Wireless.
d Select Access Points.
e In the Task List panel, select Distributed AP.
2 In the Name box, type a name (1 to 16 alphanumeric characters, with no
spaces or tabs).
3 In the DAP Number box, specify the WX switch connection number the
connection to this Distributed MAP. The range of valid connection
numbers depends on the WX switch model:
For a WX4400, you can specify a number from 1 to 300.
For a WX1200, you can specify a number from 1 to 30.
For a WXR100, you can specify a number from 1 to 8.
4 In the Serial Number box, type the serial number of the MAP.
5 In the Fingerprint box, type the 16-digit hexadecimal number of the
encryption fingerprint for the MAP. Use either of the following formats:
11:22:33:44:55:66:77:88:99:aa:bb:cc:dd:ee:ff:00
1122:3344:5566:7788:99aa:bbcc:ddee:ff00
The fingerprint for a MAP is the hash value of the public encryption key
for the MAP. The fingerprint is displayed on a label on the back of the
MAP, and is labeled RSA key. If the MAP is already installed and
operating, use the CLI command display dap status command to
display the fingerprint.
The fingerprint is used for secure communication between the WX switch
and the MAP, and applies only to Distributed MAPs.
6 Click Next.
7 Select the MAP model from the MAP Model list.
8 To select the radio type for a single-radio model, click the MAP Radio
Type box and select the radio type from the list:
11a—802.11a
11b—802.11b only
11g—802.11b/g
9 Click Next.
10 Configure the radios:
a To enable the radio, select Enabled.
Viewing and Configuring MAPs 283