Viewing And Changing Port Settings; Viewing Port Settings; Changing Port Settings - 3Com WX4400 Reference Manual

Viewing and
Changing Port
Settings

Viewing Port Settings

Changing Port
Settings
You can configure and display information for the following port
parameters:
Name
State
Type (network, MAP, or wired authentication)
Speed and autonegotiation
Power over Ethernet (PoE) state
Media type (gigabit Ethernet ports only)
Load sharing (see "Viewing and Changing Port Groups" on page 193)
1 Select the Configuration tool bar option.
2 In the Organizer panel, click the plus sign next to the WX switch.
3 Click the plus sign next to System.
4 Select Ports.
The ports and their configuration settings appear in the Content panel.
The 10/100 Ethernet ports and the gigabit Ethernet ports (if the switch
has them) are listed separately.
To change settings for a port, edit the row of information for the port.
1 In the Name box, type a name for the port (1 to 16 alphanumeric
characters, with no spaces or tabs).
2 To enable the port, select Enabled. To disable the port, clear Enabled.
By default, the port is enabled.
3 To specify the speed of a 10/100 Ethernet port, select one of the
following:
Auto—Sets the port to automatically detect the traffic speed and set
the speed accordingly. This is the default value.
10—Sets the speed to 10 Mbps.
100—Sets the speed to 100 Mbps.
The port speed for gigabit Ethernet ports is predefined as 1000 Mbps and
cannot be configured.

Viewing and Changing Port Settings

185