3Com WX4400 Reference Manual page 270

270 C 7: C
HAPTER ONFIGURING
W P
IRELESS ARAMETERS
To configure access rules only, select Access Rules and go to "Modifying
Access Rules" on page 271.
Modifying Encryption Settings
1 Select the security modes you want the SSID to support. You can select
one or more of the following:
RSN (WPA2)
WPA
Static WEP
2 Click Next.
3 If you selected RSN or WPA, you can select whether to use dynamically
generated keys, or static keys based on a passphrase.
To use dynamically generated keys, leave the Pre-shared Key box
blank.
To use static keys, type a string from 8 to 63 characters long in the
Pre-shared Key box and click Generate.
4 Click Next.
5 Select the encryption algorithms to use:
AES (CCMP)—Usually used with RSN (WPA2)
TKIP—Usually used with WPA
WEP-104—Used with dynamic WEP
WEP-40—Used with dynamic WEP
6 Click Next.
7 If you selected Static WEP, specify WEP keys.
For each key (up to four), type the key value in the corresponding key
box.
By default, data in unicast and multicast packets are encrypted using
WEP key 1. To use another key for either type of packet, select the key
number in the WEP Unicast Key Index or WEP Multicast Key Index box.
8 Click Next.
9 If the access type is Web Portal or Open Access, select the VLAN into
which you want the switch to place users of the SSID.
If you want to specify the VLAN later when configuring the access rules,
you can leave the VLAN Name box blank.