3Com WX4400 Reference Manual page 255

AES (CCMP)—Usually used with RSN (WPA2)
TKIP—Usually used with WPA
WEP-104—Used with dynamic WEP
WEP-40—Used with dynamic WEP
13 Click Next.
14 If you selected RSN or WPA in step 10, you can select whether to use
dynamically generated keys, or static keys based on a passphrase.
To use dynamically generated keys, leave the Pre-shared Key box
blank and go to step 15.
To use static keys, type a string from 8 to 63 characters long in the
Pre-shared Key box and click Generate.
15 Click Next.
16 If you selected Static WEP in step 12, specify WEP keys. Otherwise, go to
step 17.
For each key (up to four), type the key value in the corresponding key box.
By default, data in unicast and multicast packets are encrypted using
WEP key 1. To use another key for either type of packet, select the key
number in the WEP Unicast Key Index or WEP Multicast Key Index box.
17 Click Next.
18 Select or type the name of the VLAN into which you want the switch to
place voice clients.
19 Click Next.
This step and the following step do not apply if the vendor selected in
step 6 is Vocera.
If applicable, the ACEs (ACL rules) that 3WXM will configure for the voice
service are listed. For non-WMM clients, ACEs are required in order to
provide priority treatment of voice traffic. The ACEs differ depending on
the vendor you selected in step 6. The wizard describes the ACEs.
If you need to modify the ACEs, go to step 20. Otherwise, go to step 21.
20 To add an ACE, click Add Rule. 3WXM adds an ACE to the end of the
list. The ACE matches on all source and destination IP addresses and
denies them.
To modify an ACE, select the part of the ACE you want to modify, and
edit or select the new value. (For information about ACE settings, see
"Viewing and Configuring ACLs" on page 230.)
Viewing and Configuring Wireless Services 255