Trapdest Object Attributes; Default Trapdest Objects; Table 4-4. Trapdest Object States - HP T9576G06 Management Manual

Introduction to SCF for the SNMP Agent

Table 4-4. TRAPDEST Object States

State Description
DEFINED The TRAPDEST object has been configured with the SCF ADD command,
but has not been initially activated for use in the NonStop agent operations
environment.
STARTING The TRAPDEST object is in the process of starting. If an underlying resource
is unavailable, it remains in the STARTING state until the resource becomes
available. At that time it enters the STARTED state.
STARTED The TRAPDEST object is either ready to send or in the process of sending
trap messages.
STOPPED The TRAPDEST object is configured but is not currently being used by the
NonStop agent. The object has been explicitly stopped with the SCF STOP or
ABORT command.
Figure 4-10 illustrates the state transition sequence for the TRAPDEST object.

TRAPDEST Object Attributes

The following attributes are supported for the TRAPDEST object:
COMMUNITY specifies the community name included in trap messages sent to the
associated manager.
HOSTADDR specifies the Internet address of the manager to which trap messages
are to be sent.
NETWORK specifies the TCP/IP process handling the sending of trap messages
by the NonStop agent process to the manager.
For a description of these attributes, see the

Default TRAPDEST Objects

When you initially start the NonStop agent process with the default WARM (see
| COLD Custom Configuration Parameters for the RUN Command
TCPIP^PROCESS^NAME options, the NonStop agent creates a default TRAPDEST
object for each Internet address from which it receives a request.
These dynamically generated TRAPDEST objects are named "#DYNA0," "#DYNA1,"
and so on. They are stored in the SNMPCTL file.
For example, if the NonStop agent receives a request from the manager at Internet
address "130.252.86.10," it creates and starts the following TRAPDEST object:
TRAPDEST $agent-process.#DYNA0, COMMUNITY "Tandem",
NETWORK $ZTC0, HOSTADDR "130.252.86.10"
SNMP Configuration and Management Manual—424777-006
ADD Command
4- 18
TRAPDEST Object Attributes
on page 5-5.
WARM
on page 2-14) and