Snmp Error 00005; Snmp Error 00006 - HP T9576G06 Management Manual

SCF Error Messages for the NonStop Agent
Effect. This is an informational message only. Configuring more than one TRAPDEST
object that points to the same destination results in duplicate traps being sent to the
same address.
Recovery. No action is necessary.

SNMP Error 00005

SNMP E00005 Invalid wildcard specification in HOSTADDR
Cause. You provided an invalid wildcard specification as a HOSTADDR attribute
value. You defined either:
A TRAPDEST object with one or more wildcard values in the HOSTADDR
specification. Each TRAPDEST must point to a single Internet address.
An ENDPOINT or PROFILE object with a partial wildcard specification as the
HOSTADDR attribute value. Partial wildcard specifications are not supported for
the ENDPOINT and PROFILE objects.
Effect. The ADD or ALTER command is not executed.
Recovery. Define a separate TRAPDEST object for each Internet address to which
traps are to be sent. For ENDPOINT and PROFILE objects, define the object with
either a full wildcard specification ("0.0.0.0") or a specific Internet address.

SNMP Error 00006

SNMP W00006 Resource not available for obj-type: will retry
Cause. You attempted to start an object, but a resource on which the object relies is
not available.
Effect. If you were trying to start a TRAPDEST object, the object enters the
STARTING state. The NonStop agent cannot send traps to the trap destination until the
underlying resource becomes available. Each time the NonStop agent receives or
generates a trap, it attempts to access the resources whose services it requires. As
soon as the resource becomes available, the object enters the STARTED state.
If you were trying to start an ENDPOINT object, the object enters the STARTING state.
The NonStop agent cannot receive SNMP messages through that request/response
connection until the underlying resource becomes available. Using an internal timer,
the NonStop agent periodically tries to access the resources whose services it
requires. As soon as the resource becomes available, the ENDPOINT object enters
the STARTED state.
Recovery. No action is required. However, you might want to investigate the
unavailability of the resource if the object remains in the STARTING state.
connection later
SNMP Configuration and Management Manual—424777-006
B- 5
SNMP Error 00005